767 Litre Per Minute Bore Pumps

767 Litre Per Minute Bore Pumps

767 litre per minute bore pumps are the FPS-46 range of 6″ Inch bore pumps are available in Three 3 Phase.  They are suitable for 6 inch or larger bore casings.

46m3/h flow rating. 666LPM to 917LPM is the most efficient flow produced by the FPS-46 range.  However, they are capable of flows from 400LPM to 917LPM. Also, capable of heads from 15m to 480m. (see flow chart below)

If you require the FPS46 models such as the 3.7kw in Single 1 Phase 3-wire, please contact us.

Three phase contactors / starters are sold separately and are only available up to 7.5kw.

More pump details and selection advise below the displayed products (at bottom of page).

Each FPS-46 model can produce more or less than 767LPM depending on the head that it is operating at.

All the models on this page are capable of producing from 666LPM to 917LPM efficiently.  They can operate outside that range for short periods of time, but over long periods of time it may shorten the life of the motor. See image below for “Pump Operating Range”.

The amount of water that you get depends on the head that the pump is operating at.

For example, the FPS-46-7 (which is a 9.3kw bore pump), will produce 767LPM when operating at a head of 57m.  This same pump will produce 916LPM if it is operating at a head of 47m. It will produce a lesser flow of 500LPM if operating at a head of 75m.

Bore Pump Selection Hints

Please remember that the ‘Head’ is not just the depth that the pump is set at down the bore casing.  To learn more on how to calculate the ‘head’, please go here: How to Calculate the ‘Total Head’.

To learn more about how to read the flow charts, please go here: How to understand the flow charts.

Features of the 767 Litre Per Minute bore pump range

• 3″ BSP discharge.
• Stainless steel impellers and diffusers to resist corrosion.
• Heavy duty stainless steel shell assures permanent alignment of all components to increase longevity and enables higher pressures than strap designs.
• PTFE floating wear ring, ceramic bearing journal and nitrile rubber fluted bearing ensures durability against wear for long lasting performance and reliability.
• Suitable to operate in horizontal position.
• Built-in check valve to protect the pump against water hammer.
• Energy efficient hydraulic design for cost effective operation.
• Easy to install or dismantle for service in the field if necessary.
• Designed for optimal performance when powered by Franklin’s corrosion-resistant 6″ encapsulated submersible motors.
• Visit Franklin Electric’s website page for more details on the FPS SR Series of Franklin 6-Inch Bore Pumps.