304 Stainless Steel Shroud / Flow Inducer Sleeve with a 4″ BSPF outlet
Shroud are also known as a ‘Flow Inducer Sleeve’.
The 304 Stainless Steel Shroud will suit a 6″ bore pump and motor. It has a 4″ BSPF outlet 1200mm tube. This is the standard minimum length.
Extra length is available in 300mm multiples. Add $70 for every 300mm added. You will need to contact us to arrange this.
Maximum length available are 4,900mm.
This shroud is constructed of 304 stainless steel.
Motor centraliser bolts are supplied with this shroud.
Shrouds ensure water must travel the length of the motor in to the pump suction to aid in cooling the motor.
A Flow Inducer Sleeve is always required in an open body of water eg. a dam or river, or a cascading bore. A pump shroud should also be used if the pump is to be installed below water inlet level. This protects the pump from damage from falling sand and ensures correct velocity of water over motor for cooling purposes. They are also required in cascading, low yielded, top feeding bores.
Suitable for all pipe and floor mounted 10 bar pressure tanks
1" BSP inlet - Max Pressure is 10 bar = 1000 kPa. Pressure Setting is…