FPS3A-62 3 Phase Franklin Electric 4 Inch Submersible Pump and Motor Assembly

Assembly includes pump and motor only.

4400 Tri-Seal 4-Inch Bore Pump and Motor Kit.
3m³/h flow ratings
45 liters per min / 0.75 liters per second @ 315m head

The FPS-3A-62TS has a 5.5kw/7.5hp 3 phase motor.
The 3 phase will require a 3 phase contactor/starter which will need to be ordered separately.

Receive a FREE 4″ Splice Kit with every Franklin Bore Pump and Motor Combination.

There are other accessories that you will need to install your bore pump which include bore cap, drop cable, support cable, riser pipe, pressure gauge, etc. These are listed below
Please be sure that your pump and accessory selection is correct before you purchase as the onus is on you. This is why I have included suggestions below with links, to ensure you select the correct size accessories for this model pump.

Options to purchase with your kit to suit this pump

Bore Cap
This model has a 1 1/4 (32mm) discharge thread, so if you are using 32mm pipe diameter then a 1.25″ Bore Cap would be recommended.

Shroud Adapter
A shroud adapter is only needed if you are installing a 4″ pump down 6″ or larger casing.
If using 32mm pipe diameter then a 32 x 100mm (1 1/4″ riser) PVC Shroud Adapter would be recommended.

Electrical Cable
You must check with your electrician on cable size.
Always check with your electrician. He will do volt drop calculations to meet site requirements to comply with AS.

Stainless Steel Support Cable – Available in 3mm cable or 4mm cable

Stainless Steel Support Cable Grips/Clamps – Available in 3mm or 4mm to suit S/S Cable

Pressure Gauges Liquid Filled 63mm – Available in 0-800 kPa, 0-1000 kPa, 0-1600 kPa and 0-2500 kPa

3 Phase Contactor
The correct size contactor for this model is a 5.5kw/7.5hp contactor

Three 3 Phase Motor Protection
If you purchase a 3 Three phase kit, then you will need a Submonitor as your motor protection device.

3 Year Warranty