FPS1A-35TS Franklin Electric 4″ Submersible Pump and Motor Assembly.
Assembly includes pump, motor & starter.
4400 Tri-Seal 4-Inch Bore Pump and Motor Kit.
1 m³/h flow ratings
18 liters per min 0.3 liters per second @ 205m head
This model has a 2.2kw / 3hp 3-wire single 1 phase Franklin Electric submersible motor.
The 3-wire 1 phase motor requires a starter box which comes with pump & motor combo.
Receive a FREE 4″ Splice Kit with every Franklin Bore Pump and Motor Combination.
There are other accessories that you will need to install your bore pump which include bore cap, drop cable, support cable, riser pipe, pressure gauge, etc. These are listed below and are available from this website.
Please be sure that your pump and accessory selection is correct before you purchase as the onus is on you. If you are unsure, please contact me.
Options to purchase with your kit to suit this pump
Bore Caps have different size discharge threads. Please keep this in mind when purchasing your bore cap.
The splice kit is used to join the motor cable to the electrical drop cable. The splice kit makes a waterproof join. You will receive a FREE SPLICE KIT with this pump.
A pump shroud are needed for motor cooling and are only required if you are installing a 4″ pump down 6″ or larger casing.
1 Phase Cable 3-wire/4 core submersible drop cable is required. However, you must check with your electrician on cable size. He will do volt drop calculations to meet site requirements to comply with AS.
Stainless Steel Support Cable – Available in 3mm cable or 4mm cable.
Stainless Steel Support Cable Grips/Clamps – Available in 3mm or 4mm to suit S/S Cable.
Pressure Gauges Liquid Filled 63mm – Available in 0-800kPa, 0-1000kPa, 0-1600kPa & 0-2500kPa pressure ratings.
Flexible Riser Pipe
– Series 100 is for depths up to 100.The sizes are 32mm and 50mm internal diameter.
– Series 200 is for depths up to 250m. The sizes range from 40mm to 200mm internal diameter.
– As well as the couplings, ties and joiners.
The installation roller is a device that fits on the top of the bore casing. The rollers make it easy to lift and lower the bore pump down the borehole.
Single Phase Motor Protection
The motor protection device for a 1 single phase 3-wire bore pump is:
The Pumptec IR (for 2-wire & 3-wire 1 Ph from 0.37 to 1.1kw)
or the Pumptec Plus (for 2-wire, 3-wire & 3WPSC 1 Ph motors from 0.37 to 3.7kw).
There is a 3 year warranty plus a 1 year guarantee against sand locking
|Motor Size||2.2kw / 3hp|
|Phase||Single 1 Phase 3-wire|
|Rated Flow (LPM)||18|
|Discharge (mm)||32mm - 1.25"|
|Warranty Period||3 Years|